How to leverage analytics in procurement

List of the catalog of this article:

• 1,How to leverage analytics in procurement How to install a generator on a bicycle and how to achieve it?Thank you
• 2, What is the name of the small engine on the bicycle in the 1990s
• 3, Why can't the front wheel of an electric bicycle be installed on the engine to generate electricity to charge the battery during driving...
• 4, Can a generator be installed on a bicycle?

How to install a generator on a bicycle and how to achieve it? Thank you

1. It is a rubber wheel on a small DC motor shaft, and the motor is clamped on the front wheel bracket.Use the rubber wheel to touch the inner ring of the wheel, connect the motor lead to the handlebar, connect it to a flashlight head and fix it.

2. So the tooth plate will rotate at high speed with it. Where do you put your feet? It's very dangerous. The chain strength of our ordinary cars is not high enough. It is not suitable for long-term use with the motor. I have seen their successful modification. The position is added to the brake of the bicycle. Remove the brake and install the flywheel. It is connected to the motor through the chain.

3. A more convenient way is to find a generator with a power of about one to two hundred watts. It can be replaced by a permanent magnet motor of an electric tricycle. The voltage is 24v, 36v and 48v. There are several types of generators to choose according to your needs. If you charge a 24v battery, choose 36v. Just connect a 36 The bulb of v 35w can be used as a current limiter.

4. You need to buy an electric fan to study, because you can connect a secondary light-emitting tube on the plug, turn the fan with your hand, and the secondary light-emitting tube will glow, and then study ~ coils, magnets. Do vertical magnetic inductivity movement.

What is the name of a small engine on a bicycle in the 1990s

Flywheel: The flywheel is fixed at the right end of the rear axle, maintaining the same plane as the sprocket, and connected to the sprocket through the chain, forming a self The driving system of the car. Structurally, it can be divided into two categories: single-stage flywheel and multi-stage flywheel.

It seems that the gasoline engine installed on bicycles was not invented in the United States. There have been similar gasoline engines installed on bicycles in China for a long time. But most of them drive the chain and then drive the rear wheel.

The engine is installed in the bicycle and becomes a motor. I have it at home, but it's the kind of old bicycle modified in the 1980s. I haven't ridden it for many years, and it's aging there. It seems that those who are not allowed to ride horses out now will be detained. It's better to buy an electric car. It's convenient to install a white license plate without fuel money, which is environmentally friendly and economical.

Install the steam engine on the bicycle. You can choose to put the steam engine in front or behind the frame according to your own needs. When installing a steam engine, it is necessary to pay attention to the connection and layout of the steam pipe to ensure that the steam can enter and discharge smoothly.

On an ordinary bicycle, two engine tubes are installed in the rear bicycle tire position, and then an engine is equipped with an engine, and liquefied gas is connected as an energy supply to drive the jet engine.Such a bicycle equipped with a jet engine can reach a record of 70 kilometers per hour under the bold test of this foreign man.

Why can't the front wheel of the electric bicycle be installed in the engine to generate electricity and charge the battery during driving...

1. First of all, the electric vehicle range increaser is essentially a small generator. The power is not as good as the power of the electric motor and cannot provide all the required power, so it can only be used as an auxiliary, reducing The loss of battery power.

2. This is a typical power cord disconnection fault. Check whether the connection between the battery and the battery is disconnected or loose, or rusty. Check and tighten it without omission.

3. Second: The quality is uneven. Most of them are small factory products, which cannot guarantee installation, noise, vibration, durability, after-sales service, etc. Third: The power generation efficiency is relatively low. The lower the engine power, the lower the power efficiency. Similarly, the fuel efficiency of the electric 170F engine is about 20% higher than that of the 190F engine.

4. According to different cooling methods, it can be divided into water-cooled engines and air-cooled engines. The water-cooled engine has uniform cooling, reliable operation and good cooling effect, and is widely used in modern vehicle engines. According to the number of strokes, it can be divided into four-stroke internal combustion engines and two-stroke internal combustion engines. Four-stroke internal combustion engines are widely used in automobile engines.

Can a generator be installed on a bicycle?

1. You can add a small generator to the rear wheel of the bicycle, preferably DC, and connect the output to a battery pack. Normally, you can exercise. At other times, you can use the electricity stored in the battery. The power should not exceed 500W, otherwise you will have a hard time.

2. Decades ago, there was a small generator called grinding electricity. The rotating head could lean on the outer tire, and as soon as the wheel turned, it could light up the small electric beads.Today's progress: It is ideal to use LED as a lighting element. It is best to use high-brightness LED components. At the same time, it is equipped with a small rechargeable battery.

3. There is no need to add such a device to save such a little electricity; Third, mountain or road vehicles are pursuing lightweight. If such a device is added, it will increase the weight. These are the reasons why I think of. Of course, this device is also used in a few station wagons.

4. There are bicycle generators and lamps for sale. The generator is installed and fixed on the rear wheel or the front wheel. There is a friction head on the front of the generator, which mainly relies on the friction rotation of the tire to generate electricity, and then two wires are connected to the lamp, which is very convenient and simple.

5. This is not very realistic. When charging the battery, try toMaintain a constant voltage. The speed of the bicycle is basically relatively variable. The output of the engine is alternating current, and the filter should be rectified into direct current, but the bicycle is not determined to be a stable voltage, which is relatively harmful to the battery.

6. It's better to get a solar panel to get a generator. The resistance of the generator is also great, and if it breaks down, it will be embarrassing. Power generation drums can be considered, but don't think about taking the Sichuan-Tibet line. In case it breaks down and can't be repaired on the road, if you want to get an external generator.