How to identify tariff loopholes

List of the table of contents of this article:

• 1 ,How to identify tariff loopholes What is the reason for the buzzing of the refueling door engine
• 2, What is the reason for the buzzing of the Oman Guowu engine as soon as it is refueled? Oman Guowu etx runs the road and refuels...
• 3, refueling buzzing and collecting oil won't ring
• 4, If you step on the accelerator slightly higher, it will buzz
• 5, The sound of acceleration engine buzzing

What is the reason for the buzzing sound of the refueling door engine

1. The reasons for the buzzing sound of the engine refueling door are as follows: excessive carbon accumulation, including excessive carbon accumulation in the engine, throttle valve, spark plug, etc. The filtration is not good. It is often encountered that the air filter is too dirty; the purity of gasoline is not enough to form carbon inside the machine.

2. The reason for the buzzing of the throttle engine may be excessive carbon accumulation, poor filtration, insufficient purity of gasoline, aging spark plugs, engine problems, cylinder problems and idling problems.

3. Engine refuelingThe buzzing of the door may be caused by too much carbon accumulation, poor filtration, and insufficient purity of gasoline. Clean the air filter in time.

4. In the process of driving, some car owners respond to the buzzing sound of the car's refueling door. So what is the reason for the buzzing of the engine refueling door? The exhaust pipe leaks. When the exhaust pipe leaks, as long as the vehicle accelerates, it will cause the exhaust rate to increase. At this time, the vehicle is easy to make a loud roar.

What is the reason for the humming sound of the Oman Guowu engine when refueling? The Oman Guowu etx starts running and refueling...

When an abnormal sound appears at a certain speed, the speed should be maintained to operate at the abnormal sound, so that the abnormal sound exists, and then the relationship with the cylinder position should be determined.If the relationship with the cylinder position is not obvious, the distribution area of the abnormal sound vibration on the engine should be identified, and the vibration should be tested with a one-word (or cross) groove screw (screwdriver) to assist in identifying the sound part.

Models equipped with turbocharged engines, there is bound to be a difference between the sound of the sound and the naturally aspirated engine; models with engine guards installed may also make noise due to friction; some car owners, after contact with different cars, are likely to lack of mechanical knowledge, and reasonable The abnormal sound was mistaken for a vehicle malfunction.

Cause of failure: (1) The inside of the oil cup is too dirty, the filter is blocked or the oil surface of the oil cup is low. ( 2) There is a lot of air in the power steering system. ( 3) There is a foreign matter in the steering system, causing the steering pump flow control valve to be stuck.

First, check if there are any traces of friction outside?If there is, it's easy to find the reason. If the steel plate pin is not buttered for a long time, the dry grinding of the pin will also make a sound.

Refueling buzzing and collecting oil will not sound

When you step on the accelerator pedal, the engine speed will increase. At this time, it is normal for the engine to buzz. When you release the accelerator pedal, the engine speed will be reduced, so there will be no noise. This is normal. We don't need to worry.

The reasons why the oil collection device does not make a sound when the oil buzzes is as follows: 1.

After stepping on the accelerator pedal, the speed of the engine will increase. At this time, it is normal for the engine to buzz. When the accelerator pedal is released, the engine speed will decrease, so there will be no sound. This is normal. You don't need to worry.If the car breaks down, the fault light on the dashboard will be on.

The car caused by symbism makes a buzzing sound when the oil is given, and the oil collection is not noisy. Generally, it will happen in the process of insufficient torque. It is very easy to occur in the process of developing a low torque. It can be moderately oiled and then rotated at high speed before lifting semi-linkage development, but this will also increase fuel consumption.

When the bearing of the belt tensioner or the iddler rings, it will make a buzzing sound, but the oil collection will not sound. The reason is that the belt load increases when refueling, and the bearing load of the belt tensioner or idler also increases.

The car caused by resonance makes a buzzing sound when you step on the accelerator, and the oil does not make a sound. Generally, it will appear when the torque is insufficient, especially when the torque is low. It is easy to increase the speed by stepping on the accelerator appropriately and then lifting the semi-linkage start, but this will also increase fuel consumption.

Step on the accelerator slightly and it will buzz

1. There is a buzzing sound when the car's refueling door. What is the reason for the car's buzzing when stepping on the accelerator? The reason why the vehicle's refueling door buzzing is: too much carbon accumulation in the engine, poor gasoline filtration, gasoline quality Quantity problems, aging spark plugs, engine failure, cylinder failure.

2. What is the reason why the car buzzes as soon as you step on the accelerator: Oil problem: If the owner's car lacks oil or the oil is of poor quality, the owner will hear a buzzing sound every time he starts the car. Engine cylinder deficiency: mainly refers to the fact that several cylinders or one cylinder may not work properly during the operation of the engine.

3. This may be caused by damage to the engine foot pad.After this situation, it is recommended to check the foot mat of the engine. If the foot mat is damaged, it can be replaced directly. The foot pad is at the junction of the engine and the frame. The function of the foot pad is to cushion vibration and jitter. This part can improve the comfort of the car.

4. This may be caused by damage to the engine foot mat. After this happens, it is recommended to check the engine foot mats. If the foot mat is damaged, it can be replaced directly. The foot pad is at the junction of the engine and the frame. The function of the foot mat is to buffer vibration and jitter, which can improve the comfort of the car. The machine mat is a rubber product, which will age and harden if used for a long time.

The buzzing sound of the acceleration engine

The buzzing sound produced during acceleration of the gearbox problem is not always made by the engine. It is also possible that the gearbox bearing wear and lubricant reduction caused by friction 2 Engine problems If it is indeed the buzzing sound of the engine, look Is the speed very high? If the speed increases and the speed increases very slowly during the acceleration process.

The reason for accelerating the engine buzzing sound: the engine lacks cylinder or knocks the cylinder. It may be that one cylinder or several cylinders do not work.In this case, the power of the car will be obviously insufficient, and the engine may shake. The oil is dirty or there is a quality problem. The connecting rod bearing and crankshaft bearing are loose, loose, the shaft tile is melted or the size is inconsistent, and the size is rotated.

Engine "temper" failure. When the car slows down and collects the oil, there is a "poof" sound, which may be the engine "tening" failure, that is, the so-called engine "cannon release". Too much carbon accumulation in the valve or the timing of the gas distribution will produce a strange sound. Cleaning the carbon accumulation of the valve or adjusting the timing of the gas distribution.

The buzzing sound of the engine refueling door may be due to excessive carbon accumulation, poor filtration, and insufficient purity of gasoline. Clean the air filter in time.

It will be fine naturally after a while. Engine problem. If it is indeed the buzzing sound of the engine, please check the speed.It is not very high. If the speed increases during the acceleration process and the speed increases slowly, the clutch is generally slipping and the clutch kit needs to be replaced.