Data-driven multimodal transport decisions

List of catalogs of this article:

• 1,Data-driven multimodal transport decisions Where is the water inlet of the Chevrolet Cruze
• 2、Cruze engine compartment smokes and smells like oil smoke
• 4, Where to add Cruze glass water

Where is the location of the water inlet of the Chevrolet Cruze water tank

The location of the water inlet of the Cruze water tank is on the right side of the engine compartment, next to the water inlet of the wiper fluid.The automobile water tank generally refers to the automobile radiator. The radiator belongs to the automobile cooling system. The radiator in the engine water cooling system is composed of three parts: water inlet chamber, water outlet chamber, main sheet and radiator core.

The water inlet of the Cruze water tank is located on the right side of the engine compartment next to the water inlet of the wiper fluid. The automobile water tank generally refers to the automobile radiator. The radiator belongs to the automobile cooling system. The radiator in the engine water cooling system is composed of three parts: the inlet chamber, the outlet chamber, the main sheet and the radiator core.

The outlet of the Cruze car water tank is located at the bottom, which can be found by hand. It has a threaded hole that can be tightened. The car water tank generally refers to the car radiator, which is part of the car cooling system. The radiator of the engine water cooling system consists of an inlet chamber, an outlet chamber, a motherboard and a radiator core.

If you want to add antifreeze to the Cruze car tank, you need to open the front cover and see that the secondary water tank and the main water tank cover can be added near the front bumper.

How to open the front cover of Cruze?

1. How to open the front cover of the new Cruze 17The new Cruise method to open the front hood: there is a pull-wire handle under the steering wheel, which can be opened and unlocked. Then lift the hood to a certain height with both hands. Put your finger in the middle, and there will be a card that can be pushed in. After pushing in, the hood can be fully opened.

2. The hood switch of the new Cruze is located in the cab, below the light switch. Pull the snap to open the hood, and the top post can be used to support the hood. The hood has the function of protecting the engine and soundproofing.

3. The new Cruze engine cover switch is located in the cab, and the light switch is below. The engine cover can be opened by pulling the latch, and the engine cover can be held with the toppost. The engine cover has the function of protecting the engine and the effect of soundproofing.

The Cruze engine compartment smokes and smells like oil smoke

1. There are two types of white smoke. One is the water vapor excluded from driving in a low-temperature environment, which is a normal phenomenon, and the other is the white smoke caused by early ignition or the mixture is too thin. Smoke.

2. Cause analysis: It shows that the mixed gas is too thick and the combustion is incomplete. The main reasons are that the car engine is overloaded, the cylinder pressure is insufficient, the engine temperature is too low, the carburetor is improperly adjusted, the air filter is blocked, individual cylinders do not work and the ignition is too late, etc.

3. Friction of the clutch disc in the vehicle gearbox: If the manual transmission model steps on the accelerator with its big foot in a semi-linked state, it will cause violent friction on the clutch disc, resulting in smoke and burning smell in the engine.

4. Possible reasons: When the engine is running, the exhaust pipe discharges a large amount of water vapor and white smoke. You should check whether there is water in the fuel tank, whether the cylinder pad is damaged, whether the cylinder block is cracked, whether the cylinder liner seal is good, etc. When a car parked in winter or rainy season starts for the first time, white smoke can often be seen.

Where to add Cruze glass water

1. In the engine compartment, first open the hood of the car and fix the hood with the support rod. Next to the left engine, you can see a blue plastic cover, which is the position of the glass water. But if you want to replace the new glass water, you need to drain the inside first.

2. Cruze's glass water tank is on the right side of the engine. If you want to add glass water, you need to open the hood first.The following is an introduction to the method of opening the hood and how to add glass water. Method/Steps First of all, you need to open the hood. The handle to open the hood is at the bottom left of the driver's seat, and there is a sign on the handle, which is obvious.

3. The position where the car is filled with glass water is usually located inside the hood bumper under the front hood. You can follow the steps below to find the location for filling the glass water: Open the front hood: inside the vehicle near the driver's seat, look for the hood pull rod or rope at the bottom of the driver's side pedal.

4. Hello, the water on the car glass is usually in the engine compartment. You can open the cabin cover and find a sign with water spraying.

5. The position of Cruze glass water addition: open the machine cover, and there are two ports on the right side. Precautions for adding glass water to cars: Tip 1: The first step is to dilute.Generally, the glass water bought back needs to be diluted and used according to the instructions in the manual. Tip 2: Pay attention to the water capacity of the glass.